Feed clean, hum-free juice to power-hungry pedals -- with 4 Boss-type ACA outputs, 2 Line 6-type outputs, and 2 SAG outputs for simulating drained batteries
Buy Now $169.99
Power Up Your Pedals -- Clean Up Your Signal
The Voodoo Lab Pedal Power 2 Plus Universal Power Supply is the ultimate solution for powering your pedalboard and other outboard FX processors! You'll enjoy clean, filtered power via 6 x 9VDC 100mA and 2 x 9VDC 250mA regulated sources -- and clean power means better sound.
The beauty of the Power 2 Plus: all of the power outputs on this baby are completely isolated from each other. This means that you'll encounter no tone loss or power drain between different devices. With a Voodoo Lab Pedal Power 2 Plus powering your pedalboard, you can know that your outboard FX are running their best and most balanced. Moreover, you'll know that your rig is safe from unexpected surges or any "dirty" power you might find out there.
The "L6" section refers to Line 6 units, and delivers the 250mA that will allow you to run devices like the Line 6 DL4 Delay Modeler. Standard 9V effects will run from these outputs as well, if you like.
The 2 x Battery SAG Control outputs each offer 100mA of power, but also allow you to "SAG" the voltage from 4V to 9V. This feature can be enabled via the bottom panel switches. This feature is there for the most die-hard tone freaks, allowing you to experiment with the power input behind your distortion pedals, to simulate the "dying battery" tones that so many guitarists swear by.
The Voodoo Lab Pedal Power 2 Plus is handmade in the U.S.A. and comes complete with connection cables, a detachable AC power cord, and a 5-year warranty.
- SAG outpour section with controls for power sagging distortion units
- Ultra-low noise toroidal transformer
- Four selectable outputs for Boss ACA units
- Two selectable outputs for Line 6 units
The Voodoo Lab Pedal Power 2 Plus Universal Power Supply is the ultimate solution for powering your pedalboard and other outboard FX processors! You'll enjoy clean, filtered power via 6 x 9VDC 100mA and 2 x 9VDC 250mA regulated sources -- and clean power means better sound.
The beauty of the Power 2 Plus: all of the power outputs on this baby are completely isolated from each other. This means that you'll encounter no tone loss or power drain between different devices. With a Voodoo Lab Pedal Power 2 Plus powering your pedalboard, you can know that your outboard FX are running their best and most balanced. Moreover, you'll know that your rig is safe from unexpected surges or any "dirty" power you might find out there.
3 Different Sections
You'll notice that the front panel of the Pedal Power 2 Plus is divided in ACA, L6, and SAG sections. The 4 outputs in the ACA section each deliver 100mA appropriate for 9V battery-operated pedals. These can also power Boss pedals that require the ACA adapter and operate at 12V. Just flip the switch on the bottom of the Power 2 Plus to change from 9V to 12V on any output!The "L6" section refers to Line 6 units, and delivers the 250mA that will allow you to run devices like the Line 6 DL4 Delay Modeler. Standard 9V effects will run from these outputs as well, if you like.
The 2 x Battery SAG Control outputs each offer 100mA of power, but also allow you to "SAG" the voltage from 4V to 9V. This feature can be enabled via the bottom panel switches. This feature is there for the most die-hard tone freaks, allowing you to experiment with the power input behind your distortion pedals, to simulate the "dying battery" tones that so many guitarists swear by.
Ground Loops, Begone
Most of the noise and hum musicians encounter onstage or in the studio is caused by ground loops. With its isolated outputs, the Voodoo Lab Pedal Power 2 Plus breaks unwanted ground paths before they even form.9 Isolated Outputs
Meanwhile, the Pedal Power 2 Plus employs a specially designed, ultra-low noise toroidal transformer. By placing separate balanced windings on each of the 9 outputs, the Pedal Power 2 Plus eliminates the magnetic field noise caused by most standard "wall wart" power adapters.No More Noise or Hum
Any power supply can only be as good as its own power input, right? The exceptionally clean sound you'll hear coming from the Voodoo Lab Pedal Power 2 Plus owes to its use of an audiophile-grade linear power supply that prevents the transient noises and hum caused by standard "switching" transformers.The Voodoo Lab Pedal Power 2 Plus is handmade in the U.S.A. and comes complete with connection cables, a detachable AC power cord, and a 5-year warranty.
Features:
-6 x 9VDC 100mA and 2 x 9VDC 250mA regulated sources- SAG outpour section with controls for power sagging distortion units
- Ultra-low noise toroidal transformer
- Four selectable outputs for Boss ACA units
- Two selectable outputs for Line 6 units